New IN·GAS
The practical, elegant and safe concealed ball valve for fuel gas
Built-in ball valve IN·GAS according to UNI CIG 7129, UNI EN 331 approved.
Male/male and female/female connections ¾" suitable for any type of straight or curved fitting (copper, iron or multilayer pipe).
The clearly visible and inspectionable tap can be replaced without splitting. Quick installation thanks to the quick coupling and the housing of the pipe protection sleeves inside the box.
The compact shell, only 50 mm deep, can be recessed into thin walls.
Material specification
Approved EN 331
|
COMPONENT |
MATERIAL |
DESCRIPTION |
||
|---|---|---|---|---|
| 1 | BALL VALVE | CW 617 N UNI EN 12165 | FORGED | |
| 2 | INSPECTIONABLE SHELL | PLASTIC | FORGED | |
| 3 |
BALL |
CW 614 N UNI EN 12164 | MACHINED, CHROME PLATED | |
| 4 | BALL GASKETS | P.T.F.E. | PURE | |
| 5 | STEAM | CW 614 N UNI EN 12164 | MACHINED | |
| 6 | O-RINGS | ELASTOMER | SUITABLE FOR USE WITH GAS EN549 | |
| 7 | LEVER HANDLE | PLASTIC | FORGED | |
| 8 |
SCREW |
8G STEEL |
ZINC-PLATED |
|
| 9 | PLUG | PLASTICA | FORGED |
Characteristics NEW IN•GAS
| INTERNATIONAL APPROVALS | The IN•GAS concealed ball valve meets the UNI CIG 7129 standards and it's homologated UNI EN 331. |
| END CONNECTIONS | 3/4" male/male and female/female threads, compatible with any type of fittings: straight or curved (copper, iron and multilayer hose). Threads ends UNI ISO 228/1. |
| USES |
Fuel gas:
|
| CHARACTERISTICS | Compactness: depth of the shell 50 mm. Can be concealed even in walls of reduced thickness. Valve replacement without splits. In the same box possibility of entry from the bottom, side or mixed. Ventilated box and possibility of being sealed by specific sealant channel. The upper seal is insured by two o-ring for gas. The lateral seal is guaranteed by two P.T.F.E. seals. The fittings and the covering plates are supplied separately |
| WORKING PRESSURE | For fuel gas 5 MOP. |
| TEMPERATURE LIMITS | For fuel gas from -20°C to +60°C |
| INSTALLATION | Quick installation with hooks on shell and screws (supplied). The hose protection sheaths must be inserted inside the shell. |
Download
New In Gas In Gas Multi 1.36 MB
